New Insight Table for Sweet 16
I am trying to put my Sweet 16 into an InSight table. The instructions say to raise the machine stand plate to its highest position, and tighten the screws. Then put your machine in.
I got all the way through all the installation, and the needle plate is about 1/8 - 1/4 inch below the table top. Is that an issue? I thought it should be more even with the table top. Since the stand plate is already as high as it can go, I can't really adjust it.
My second issue is that the insert assembly doesn't seem to be even with the front of the table. One side of it is, but the other is not. I assume this means I did something wrong earlier in the installation, but I don't know what I should look at.
I would really like some help!
-
Mindy,
Please contact HQ Technical Solutions and they can help you with these questions.
Best regards,
Kristina Whitney
Handi Quilter Studio Educator
0 -
I did this morning, and they were really not much help. I guess I am going to return the table, which is turning out to be much more trouble than its potential worth. I was fine without a stitch regulator. I should have left well enough alone.
0
Please sign in to leave a comment.
Comments
2 comments